Computer Aided-Design(Key Ring Design)

Since this is a refresher of the keyring that we did before, I did not learn anything new other than familiarizing myself with using Fusion 360 again.

First of all, I create a rectangle of 65mm by 25mm. Then, I offset the rectangle by 2mm. 

After that, I use the fillet tool to smoothen the edges of the rectangle. These steps are shown in the picture below.

I added the circle and my name. The hole is to allow the keyring to be attached.

In the last step, I extrude the specific part of the model like the border of the keyring, my name, and the board that my name is on. The circle is not extruded to create a hole for the attachment.

What I realized after doing this refresher was that the software is very easy for newcomers to pick up software and use it without prior knowledge.